General Description

The power sunroof (CF5 option) has the following features:
^ A manually operated sunshade. A recess is provided in the sunshade to be used to push the shade open or pull it shut.
^ An express module at the front of the sunroof module, allows the window panel to stop in the closed, vent and fully open positions.
^ The Position Encoding System (PES) module contains the limit switches for the window panel operation. Its gearing drives the window into the desired position. The window panel must be in the closed position when this unit is replaced.
^ The sunroof actuator attaches to the PES module and contains the driveshaft that drives the gearing in the PES. This driveshaft will turn infinitely in both directions.
^ The power sunroof switch is a 2 position rocker type switch which electrically operates the power sunroof. The switch is located in the headliner in front of the sunroof.
Press and hold the front indent position to move the sunroof glass to the vent position. Press and hold rear indent and the sunroof will return to the full closed position.
Press rear indent once and the sunroof glass will slide to the full open position automatically (express open).
Press and hold the front indent position on the control switch in order to close the sunroof window from the open position. The switch must be held until the window reaches a desired position or until it closes completely.
^ A drain trough is positioned under the sunroof glass panel. Water is collected by this trough and is drained off by drain hoses connected at each corner.
^ The glass panel seal fits around the glass panel and is used to seal the opening between the glass panel and the roof panel.
^ The sunroof electrical harness is routed to join the body harness at the right rear pillar.

"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID". RPO Codes