Low Beams (ZR2)

Battery positive voltage to the headlamp switch is supplied by the HDLP SW fuse in the IP fuse block. When the headlamp switch is in the HDLP position, the headlamp power relay coil is energized. A voltage signal is also sent to the Body Control Module (BCM) signaling that the headlamp switch is activated. When the headlamp switch is in the AUTO or PARK position and the ambient light sensor detects darkness, the BCM produces a voltage signal that will also energize the headlamp power relay. The headlamp power relay coil is grounded at G102. When the headlamp power relay is energized, the relay supplies battery voltage to the LT HDLP and RT HDLP fuses. Both low beam headlamps are grounded by the multifunction headlamp dimmer switch in the low beam position through the normally closed Daytime Running Lamp (DRL) relay to G102.

"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID". RPO Codes