NVG 136-NP4

Transfer Case Shift Control Module -Replacement

Removal Procedure





1. Remove the right hinge trim panel.

Important: Before performing the following service procedure, ensure that the ignition is in the off position.





2. Disconnect the 2 wiring harness connectors from the transfer case control module.





3. Remove the mounting nuts for transfer case control module to the retainer.
4. Remove the transfer case control module from the mounting bracket.

Installation Procedure





1. Install the transfer case control module on the mounting bracket.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the mounting nuts on the mounting bracket.
Tighten the nut to 6 Nm (53 inch lbs.).





3. Install wiring harness connectors to the transfer case control module.





4. Install the right hinge trim panel.