Clutch Cable Housing Replacement
Clutch Cable Housing ReplacementFront Drive Axle
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the front differential carrier shield (if equipped).
3. Disconnect the electrical connector from the four-wheel drive indicator switch.
4. Remove the four-wheel drive indicator switch.
5. Remove the three bolts from the clutch cable housing.
6. Separate the clutch cable housing from the differential carrier assembly.
7. Insert a screwdriver, or similar tool, into the clutch cable housing opening and disconnect the retainer spring from the clutch cable.
8. Remove the clutch cable and the clutch cable housing from the differential carrier assembly.
9. Disconnect the clutch cable coupling nut from the clutch cable housing.
10. Remove the clutch cable housing.
Installation Procedure
1. Install the clutch cable housing.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the clutch cable housing bolts.
Tighten the clutch cable housing bolts to 48 Nm (36 ft. lbs.).
3. Insert the clutch cable into the clutch fork.
Engage the spring retainer in order to retain the clutch cable.
4. Install the clutch cable coupling nut to the clutch cable housing.
Tighten the clutch cable coupling nut to 10 Nm (89 inch lbs.).
5. Install the four-wheel drive indicator switch.
Tighten the four-wheel drive indicator switch to 5 Nm (44 inch lbs.).
6. Connect the electrical connector to the four-wheel drive indicator switch.
7. Install the front differential carrier shield (if equipped).
8. Lower the vehicle.