Blower Motor Replacement

REMOVAL PROCEDURE




1. Remove the right side IP insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gauges and Console.
2. Disconnect the blower motor electrical connector.
3. Remove the blower motor mounting screws.




4. Remove the blower motor from the HVAC module assembly.

INSTALLATION PROCEDURE




1. Install the blower motor to the HVAC module assembly.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the blower motor mounting screws.

Tighten
Tighten the screws to 1.8 N.m (16 lb ft).




3. Connect the blower motor electrical connector.
4. Instal the right side IP insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gauges and Console.