HVAC Control Module Replacement

REMOVAL PROCEDURE




1. Remove the IP trim plate.
2. Remove the HVAC control module retaining screws.




3. Pull the HVAC control module straight out from the instrument panel.
4. Disconnect the HVAC control module electrical connectors.

INSTALLATION PROCEDURE




1. Connect the HVAC control module electrical connectors.
2. Push the HVAC control module into instrument panel opening.

NOTE: Refer to Fastener Notice in Service Precautions.




3. Install the HVAC control module retaining screws.

Tighten
Tighten the screws to 2.5 N.m (22 lb in).

4. Install the IP trim plate.