A/C Refrigerant Pressure Sensor

The A/C system is protected by the A/C refrigerant pressure sensor. The sensors' output to the PCM is variable and is dependent upon pressure inside the line. A higher pressure results in a higher voltage output. The A/C pressure is constantly monitored in order to allow the A/C compressor clutch to disengage as needed. If line pressures climb above 2979 kPa (432 psi), the PCM will turn off the A/C compressor clutch until the pressure lowers to 1620 kPa (235 psi).

If line pressures tall below 179 kPa (26 psi), the PCM will turn off the A/C compressor clutch until the pressure raises to 207 kPa (30 psi).

A 5 volt reference signal is sent out over the 5 volt reference circuit, from the PCM, to the A/C refrigerant pressure sensor. The PCM monitors the A/C pressure by monitoring the voltage drop in the sensor on the A/C pressure sensor signal circuit. This circuit is how the PCM monitors HVAC pressures. Ground for the A/C refrigerant pressure sensor is provided by the low reference circuit.