Inflatable Restraint Instrument Panel Module Replacement

CAUTION: When you are carrying an undeployed inflator module:
^ Do not carry the inflator module by the wires or connector on the inflator module
^ Make sure the bag opening points away from you

When you are storing an undeployed inflator module, make sure the bag opening points away from the surface on which the inflator module rests. When you are storing a steering column, do not rest the column with the bag opening facing down and the column vertical. Provide free space for the air bag to expand in case of an accidental deployment. Otherwise, personal injury may result.

REMOVAL PROCEDURE




1. Disable the SIR system.
2. Remove the IP compartment and IP compartment lamp electrical connector.
3. Remove the inflatable restraint IP module pigtail harness clips from the IP carrier bracket.
4. Remove the inflatable restraint IP module mounting fasteners (4) that attach the inflatable restraint IP module to the IP.
5. Remove the inflatable restraint IP module bolts (5) that attach the inflatable restraint IP module to the cross-car beam.
6. Remove the inflatable restraint IP module (1) from the vehicle.

INSTALLATION PROCEDURE




1. Install the inflatable restraint IP module (1) to the vehicle.
2. Install the inflatable restraint IP module bolts (5).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the inflatable restraint IP module mounting fasteners (4).

Tighten
Tighten fasteners to 10 N.m (89 lb in).

4. Install the inflatable restraint IP module pigtail harness clips to the IP carrier bracket.
5. Install the IP compartment lamp electrical connector and IP compartment.
6. Enable the SIR system.