Front

Wheel Speed Sensor Replacement -Front
Removal Procedure

Important: The front wheel speed sensors and rings are integral with the hub and bearing assemblies.

If a speed sensor or a ring needs replacement, replace the entire hub and bearing assembly. Do not service the harness pigtail individually because the harness pigtail is part of the sensor. Refer to Wheel Bearing/Hub Replacement - Front.

1. Raise and support the vehicle on a suitable hoist. Refer to Vehicle Lifting.
2. Remove the front tire and wheel assembly.





3. Remove the front wheel speed sensor jumper harness electrical connector (1) from the front wheel speed sensor connector (3).





4. Remove the hub and bearing assembly (2). Refer to Wheel Bearing/Hub Replacement - Front.

Installation Procedure





1. Install the hub and bearing assembly (2) to the vehicle. Refer to Wheel Bearing/Hub Replacement - Front.





2. Install the front wheel speed sensor jumper harness electrical connector (1) to front wheel speed sensor connector (3).
3. Install the wheel and tire assembly.
4. Lower the vehicle.
5. Turn the ignition switch to the RUN position with the engine off.
6. Perform Diagnostic system check. Refer to Diagnostic System Check - ABS.