Ignition Lock Cylinder - Rotates

Removal Procedure
1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Starting and Charging.

Caution: Refer to SIR Handling Caution in Service Precautions.

2. Disable the SIR system. Refer to Disabling the SIR System in Air Bags and Seat Belts.
3. Remove the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in Air Bags and Seat Belts.
4. Remove the steering wheel. Refer to Steering Wheel Replacement.
5. Remove the tilt lever.
6. Remove ONLY the steering column LOWER shroud. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle.
7. Remove the steering column upper shroud FASTENERS ONLY.

8. Lift the upper steering column shroud in order to gain access to the lock cylinder access hole (1).
9. Insert the bent tip awl into the ignition lock cylinder access hole (1).

10. Turn the ignition lock cylinder to START.

11. Use the bent tip awl in order to push down on the ignition lock cylinder retainer.
12. Release the ignition lock cylinder to RUN.

13. Remove the ignition lock cylinder from the lock module.

Installation Procedure

1. Insert the ignition lock cylinder through the upper shroud.
2. Align the lock cylinder retaining tab and the position tab with the slots in the lock housing.
3. Push the lock cylinder into the lock housing completely.
4. Install the steering column upper shroud. Refer to Steering Column Trim Covers - Assemble - Off Vehicle.
5. Install the lower shroud. Refer to Steering Column Trim Covers - Assemble - Off Vehicle.
6. Install the tilt wheel lever.
7. Install the steering wheel. Refer to Steering Wheel Replacement
8. Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in Air Bags and Seat Belts.
9. Enable the SIR system. Refer to Enabling the SIR System in Air Bags and Seat Belts.
10. Connect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Starting and Charging.