Ignition Switch

Removal Procedure

Caution: Refer to SIR Handling Caution in Service Precautions.

1. Disable the SIR system. Refer to Disabling the SIR System in Air Bags and Seat Belts.
2. Disconnect the battery negative cable from the battery. Refer to Battery Negative Cable Disconnect/Connect Procedure in Starting and Charging.
3. Remove the left side closeout insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gauges and Wiring Indicators.
4. Disconnect the steering column electrical connector from the vehicle.
5. Remove the steering column shrouds. Refer to Steering Column Trim Covers - Disassemble -Off Vehicle.
6. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement - On Vehicle (Cylinder Rotates) or Ignition Lock Cylinder Replacement - On Vehicle (Unable to Rotate Cylinder).
7. Remove the ignition switch. Refer to Ignition and Key Alarm Switch Assembly - Disassemble - Off Vehicle.

Installation Procedure

1. Install the ignition switch. Refer to Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle.
2. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement - On Vehicle (Cylinder Rotates) or Ignition Lock Cylinder Replacement - On Vehicle (Unable to Rotate Cylinder).
3. Install the steering column shrouds. Refer to Steering Column Trim Covers - Assemble -Off Vehicle.
4. Connect the steering column electrical connector to the vehicle.
5. Install the left side closeout insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gauges and Wiring Indicators.
6. Connect the battery negative cable to the battery. Refer to Battery Negative Cable Disconnect/Connect Procedure in Starting and Charging.
7. Enable the SIR system. Refer to Enabling the SIR System in Air Bags and Seat Belts.