SIR Steering Wheel Module Coil - Assemble

1. Align the block tooth on the race and upper shaft assembly (1) to the 12 ' clock position.
2. Put the lock cylinder in the LOCK position and remove the key.
3. A new inflatable restraint steering wheel module coil will be precentered.
4. If reusing the original inflatable restraint steering wheel module coil refer to Inflatable Restraint Coil Centering-Off Vehicle (Column Shift And Floor Shift).





5. Align the inflatable restraint steering wheel module coil (2) with the horn tower sticking through the shaft lock shield assembly (1).

Important: The retaining ring (1) must seat securely on the groove of the race and upper shaft assembly (2).





6. Install the retaining ring (1).
7. If using a new inflatable restraint steering wheel module coil, remove and dispose of the orange tab.





8. Install the wire harness assembly (4) into the wire harness strap (5).
9. Install the wire harness strap (2) into the steering column tilt head assembly (1).
10. Install the wire harness straps (3) onto the wire harness assembly (4).
11. Install the upper and lower trim covers. Refer to Steering Column Trim Covers-Assemble-Off Vehicle.