Body - Rattle From Liftgate Area While Driving

File In Section: 08 - Body and Accessories

Bulletin No.: 03-08-59-002

Date: April, 2003

TECHNICAL

Subject:
Rattle in Liftgate Area While Driving
(Install Insulator)

Models:
2001-2003 Chevrolet Venture
2001-2003 Oldsmobile Silhouette
2001-2003 Pontiac Montana

Condition

Some customers may comment on a rattle noise coming from the liftgate area of the vehicle while driving.

Cause

The rear radio speakers mounted in the rear lingate may have a loose fit. This may cause a rattle noise while driving the vehicle.

Correction

Install insulator using the following procedure:

1. Remove the rear liftgate inside trim panel and set aside.

2. Remove the rear radio speakers from their rear mounting positions.

3. The insulator can be cut from a 25 mm (1 in) wide roll cloth portion of the 3M(R) Scotchmate Hook and Loop Fastening System P/N 06481, or equivalent. Make the insulator by cutting the CLOTH portion of the roll approximately 38 mm (1-1/2 in) long.





4. Remove the paper from the adhesive side of the insulator and install the insulator on the speaker outer edge in front of the silver retainer. Refer to the illustration above.

5. install the rear radio speakers back in their rear mounting positions. The speakers should now fit tight in their mounting positions.

6. Install the rear liftgate inside trim panel back into its position.

Warranty Information





For vehicles repaired under warranty use the table.





Disclaimer