HVAC Control Module Replacement

REMOVAL PROCEDURE




1. Remove the IP accessory trim plate.
2. Remove the HVAC control module screws.
3. Depress the HVAC control module tabs (3) and remove the HVAC control module (2) from the IP (4).
4. Disconnect the electrical connectors (1) from the HVAC control module (2).

INSTALLATION PROCEDURE




1. Connect the electrical connectors (1) to the HVAC control module (2).

IMPORTANT: Ensure that the HVAC control module tabs (3) lock into place.

2. Install the HVAC control module (2) into the IP (4).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the HVAC control module screws.

Tighten
Tighten the screws to 1.9 N.m (17 lb in).

4. Install the IP accessory trim plate.