Transfer Case Shift Control Module Replacement
Transfer Case Shift Control Module ReplacementRemoval Procedure
Important: The access panel is removed in order to visually see the electrical connectors and the location of the transfer case control module. It will also be easier to see the mounting and alignment slots for the transfer case control module mounting bracket.
1. Remove the access panel.
2. Remove the knee bolster panel.
3. Remove the lower instrument panel cover.
4. Remove the left hand heat, vent and air conditioning vent.
5. Remove the three electrical connectors from the transfer case control module.
6. Remove the transfer case control module.
Important: When removing the transfer control module, it is not uncommon for the mounting bracket to be removed at the same time the transfer case control module is removed.
7. Remove the transfer case control module from the mounting bracket.
Installation Procedure
Important: The following service procedure is more easily performed if the mounting bracket and the electrical connectors are installed on the transfer case module before installing the transfer case module to the central support bracket.
1. Install the mounting bracket to the transfer case control module.
2. Install the electrical connectors to the transfer case control module.
3. Install the transfer case control module assembly to the center support bracket.
4. Install the left hand heat, vent, and air conditioning vent assembly.
5. Install the lower instrument panel cover.
6. Install the knee bolster panel.
7. Install the access panel.
8. Program the transfer case shift control module. Programming and Relearning