Operation CHARM: Car repair manuals for everyone.
Home >> Oldsmobile Truck >> 2003 >> Bravada 4WD L6-4.2L VIN S >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Relays and Modules - Computers and Control Systems >> Engine Control Module >> Service and Repair

Engine Control Module: Service and Repair

POWERTRAIN CONTROL MODULE (PCM) REPLACEMENT

Service of the powertrain control module (PCM) should normally consist of either replacement of the PCM or electrically erasable programmable read only memory (EEPROM) programming. If the diagnostic procedures call for the PCM to be replaced, the PCM should be inspected first to see if the correct part is being used. If the correct part is being used, remove the faulty PCM and install the new service PCM.

IMPORTANT:
- To prevent internal PCM damage, the ignition must be OFF when disconnecting or reconnecting power to the PCM. For example, when working with a battery cable, PCM pigtail, PCM fuse, or jumper cables.
- Remove any debris from the PCM connector surfaces before servicing the PCM. Inspect the PCM module connector gaskets when diagnosing or replacing the PCM. Ensure that the gaskets are installed correctly. The gaskets prevent contaminant intrusion into the PCM.

Removal Procedure




1. Loosen the PCM harness connector bolts (1) from the center of the PCM harness connectors.
2. Remove the PCM harness connectors (3) from the PCM (2).

NOTE: In order to prevent internal damage to the PCM, the ignition must be OFF when disconnecting or reconnecting the PCM connector.

3. Remove the PCM mounting nuts and bolts (4).
4. Remove the PCM (2) from the intake manifold.

NOTE: Refer to PCM and ESD Notice in Service Precautions.

5. Remove the PCM mounting studs from the intake manifold, if necessary.

Installation Procedure




1. Install the PCM mounting studs to the intake manifold, if removed.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the studs to 6 N.m (53 lb in).

2. Install the PCM (2) to the intake manifold.
3. Install the PCM mounting nuts and bolts (4).

Tighten
Tighten the nuts and bolts to 10 N.m (88 lb in).

4. Install the PCM harness connectors (3) to the PCM body.
5. Tighten the PCM harness connector retaining bolts (1).

Tighten
Tighten the bolts to 8 N.m (71 lb in).

6. If a new PCM is being installed, the PCM must be programmed. Refer to Service Programming System (SPS) (Remote Procedure)Service Programming System (SPS) (Pass-Thru Procedure)Service Programming System (SPS) (Off Board Remote Procedure)Service Programming System (SPS) (Off Board Pass-Thru Procedure) in Programming. Programming and Relearning
pro multis · About Operation CHARM