Wiring Harness Replacement - Endgate

Wiring Harness Replacement - Endgate

Removal Procedure

1. Open the end gate.
2. Remove the end gate trim panel.
3. Remove the end gate control module.
4. Remove the end gate inner reinforcement panel.
5. Remove the end gate window.




6. Remove the bolt (2) retaining the wiring harness to the body.
7. Release the retainers (3) retaining the wiring harness grommet to the body.
8. Disconnect the end gate wiring harness to body harness connector (1).
9. Disconnect the rear washer hose connection (4).




10. Disconnect the window regulator connector (3).
11. Disconnect the rear wiper motor connector (2).
12. Disconnect the rear high mounted brake lamp connector (5).
13. Disconnect the relay connector (4).




14. Disconnect the left side upper and lower latch connectors (1).
15. Disconnect the right side upper latch connector (4).
16. Release the retainers attaching the end gate wiring harness to the end gate.
17. Push the end gate harness grommet (2) into the end gate.
18. Pull the end gate harness to body harness connector (3) through the opening in the end gate.
19. Remove the end gate wiring harness from the end gate.

Installation Procedure




1. Install the end gate wiring harness to body harness connector (3) into the small access hole of the end gate, and out the end gate wiring harness grommet hole.
2. Install the end gate wiring harness grommet (2) into the hole in the end gate.
Ensure the grommet is fully seated in the end gate.
3. Install the retainers attaching the end gate wiring harness to the end gate.
4. Connect the right upper latch connector (4).
5. Connect the left upper and lower connectors (1).




6. Connect the relay connector (4).
7. Connect the rear high mounted brake lamp connector (5).
8. Connect the rear wiper motor connector (2).
9. Connect the window regulator connector (3).




10. Connect the rear washer hose connection (4).
11. Connect the end gate wiring harness to body harness connector (1).
12. Install the end gate wiring harness grommet to the body.

Notice: Refer to Fastener Notice in Service Precautions.

13. Install the bolt retaining the wiring harness to the body.

Tighten the wiring harness bracket bolt to 10 N.m (89 lb in).

14. Install the end gate window.
15. Install the end gate inner reinforcement.
16. Install the end gate control module.
17. Install the end gate trim panel.
18. Close the end gate.
19. Perform the window learn cycle. Refer to Window Learn Cycle - Endgate.