Functional Inspection 2

Functional Inspection 2
Functional Inspection 2 is a mechanical system inspection for both the left and right side Gerotor pumps, pistons, and clutch packs and will assist in determining if:
^ The clutch pump check valve is in the "open" position.
^ The left and right side Gerotor pumps have the ability to "pull" fluid from the sump and send a variable and progressive rate of pressurized fluid to the left and right side clutch pack pistons.
^ The left and right side pistons will engage the specific side clutch packs at a progressive rate.
^ There is a mechanical connection between the rear differential ring and pinion, the propeller shaft, the transfer case, and the transmission assembly.
1. Raise the vehicle on a hoist. Lift the vehicle in a manner that will allow ail four wheels to rotate during testing.
2. Start the engine.
3. The gear shift lever should be in the PARK position.
4. Rotate, by hand and in a forward direction, a rear wheel at a slow rate of speed. Rotation of the wheel should be possible.
5. Rotate, by hand and in a forward direction, the opposite side rear wheel at a slow rate of speed. Rotation of the wheel should be possible.
6. Rotate, by hand and in a forward direction, a rear wheel at a fast rate of speed. A properly operating pump, piston, and clutch pack will activate and create a progressive increase in wheel rotational resistance.
7. Rotate, by hand and in a forward direction, the opposite side rear wheel at a fast rate of speed. A properly operating pump, piston, and clutch pack will activate and create a progressive increase in wheel rotational resistance. Failure to feel a progressive rate of resistance may indicate a "closed" clutch pump check valve, malfunctioning Gerotor pump, piston, clutch pack, or valves internal to the unit.