Radio Replacement

RADIO REPLACEMENT

REMOVAL PROCEDURE

1. Remove the instrument panel accessory trim plate.




2. Remove the bolts/screws from the radio.
3. Remove the radio from the center support bracket enough to access the connectors at the rear of the radio.




4. Disconnect the electrical/audio and antenna cable connectors from the radio.
5. Pull straight out from the instrument panel in order to remove the radio.

INSTALLATION PROCEDURE




1. Connect the electrical/audio and antenna cable connectors to the radio.




2. Install the radio into the I/P center support bracket. Align the radio locator tab into the I/P center support bracket locator hole.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the bolts/screws to the radio.

Tighten
Tighten the bolts/screws to 2.5 N.m (22 lb in).

4. Install the instrument panel accessory trim plate.
5. Perform the radio set up procedure. Refer to Radio Setup.