Test A - Setting the Compass Zone

Compass Variation Zones:

A: SETTING THE COMPASS ZONE
To set the compass to the proper zone, first determine the correct zone for your location. Once the correct zone is determined, display the compass zone setting by pressing the calibrate switch in the mirror. The calibrate switch can be pressed by inserting the end of a paper clip in the hole on the bottom of the mirror. Continue to press and hold the calibrate switch for 5 seconds until the zone number appears in the display. When the zone setting is displayed it can be changed by again pressing the calibrate switch, until the correct zone appears. Once the correct zone appears, stop pressing the calibrate switch and the display will show compass direction within a few seconds. The zone setting will not be lost when the mirror and the ignition are turned OFF. The zone should require resetting only when the vehicle is outside of the zone for which is set.