Tachymetric Relay - Parts Supercession

89peugeot01

BULLETIN NO. 322


DATE: January, 1989
SUBJECT: TACHYMETRIC RELAY - PARTS SUPERCESSION

THIS BULLETIN SUPERCEDES BULLETIN NO. 310 DATED NOVEMBER, 1988 FOR THE REVISED PART NUMBER OF FLAG TERMINAL

AFFECTED VEHICLES: 1980 TO 1985 505 WITH XN6 ENGINE

PARTS NEEDED:

1 - P/N 1452.05 - new tachymetric relay 1 - P/N 6540.28 - flag terminal 1 - P/N 0065.T5 - adapter harness

PROBLEM:

- Tachymetric relay P/N 6555.05 has been superceded by P/N 1452.05 (for 505 XN6 1986/87).

- In order to install the new relay, it, is necessary to use an adapter harness to fit the old connector and supply power in the cranking mode.

PROCEDURE:

- Remove lower steering column shell
- Remove lower left dash panel
- Disconnect and remove the old relay (located on left side of steering column toward the bottom)
- Install the new relay in its place
- Plug the adapter harness male connector into the vehicle harness tachymetric relay female connector
- Disconnect wire connector from two-tone chime located on the right hand side of steering column
- Remove wire #45 from the connector and cut it off
- Snake the long wire coming from the new relay connector, terminal #1, next to existing wiring harness and through existing wire tires to ensure there is no interference with the steering column
- Strip the end of this wire and wire #45
- Crimp both wires together using a new P/N 6540.28 terminal, making a double crimp with the Proner tool (P/N 9788.16) using slot no. 2.
- Push new terminal back into connector until it clicks into position
- Reconnect wire connector to two-tone chime and test by starting the engine
- Reinstall panels in reverse order of removal

WARRANTY INFORMATION:

Damage Code: 655505
Operation Number: 991212
Time Allowance: 0050 hours