Operation CHARM: Car repair manuals for everyone.

Keyless Entry Receiver: Service and Repair






In the event that a transmitter is lost, the "old" and "new" transmitter(s) will need to be programmed into the remote control door lock receiver's memory. Up to four transmitters may be programmed.

Important
^ Once the remote control door lock receiver enters the programming/diagnostic mode, the programming of the first transmitter erases all previous transmitter programming information, requiring the programming of all transmitters.
^ Program only one vehicle remote control door lock receiver at a time. If multiple receivers are being programmed simultaneously, it is possible that the same transmitter could be programmed to mow than one remote control door lock receiver.

1. Remove the ignition key from the ignition lock cylinder
2. Remove the "MALL PGM" fuse from the fuse panel.
3. Close all of the doors and liftgate.
4. Turn the ignition lock cylinder to "ACC".
5. Turn the ignition lock cylinder to "OFF", then back to "ACC" within 1 second.
6. Open, then close any vehicle door. A chime will be heard when the system enters the BCM programming/diagnostic mode.
7. Press and HOLD the transmitter "LOCK" and "UNLOCK" buttons simultaneously for 14 seconds.

Important
^ After 7 seconds, a chime may be heard confirming successful SYNCHRONIZATION.
^ It is necessary to wait approximately 14 seconds for a second chime that will confirming successful PROGRAMMING.

8. Repeat step number 8 on each additional transmitter to be programmed.
9. Remove the ignition key from the ignition lock cylinder.
10. Install the "MALL PGM" fuse back into the fuse panel.