Seats: Description and Operation

Both power seats receive power from the fuse block from the PWR SEAT/PSD Fuse through circuit 340 to S302. S302 then splits and goes to each seat adjuster switch. The ground is supplied using circuit 550 to each seat adjuster switch from S333, and from there to G301.

There are three reversible motors that operate each power seat. The front height and rear height of the seat are operated by separate motors. Each can be raised or lowered independently of the other. When the entire seat switch is pushed to the UP or DOWN position, both motors run to move the front and rear of the seat at the same time.

The forward/back adjuster motor is operated by the entire seat switch. When it is held in the FORWARD position, battery voltage is applied through the switch contacts and circuit 285 to the forward/back adjuster motor. The motor is grounded through circuit 284 and the seat adjuster switch to G301.

In the BACK position, circuit 284 receives battery voltage and circuit 285 is grounded. This reversed polarity causes the motor to run in the opposite direction and drive the seat backward.

The front and rear adjuster motors work in a similar way when the front or rear height switch is operated.

To raise the entire seat, the entire seat switch is held in the UP position. This applies battery voltage through circuit 282 and circuit 286 to the rear seat and front seat motors. The motors are grounded through circuit 283 and circuit 287 and the seat adjuster switch to G301. Both motors run to drive the entire seat up. A similar action occurs to move the entire seat down.

Each motor contains a solid state self-resetting circuit breaker to protect it from overload.