Front A/C

Remove or Disconnect

1. Right-side instrument panel insulator.
2. Electrical connectors from blower motor resistor/relay.
3. Loosen (do not remove) both forward mounting screws.
^ Blower motor resistor/relay opening is slotted as access is extremely limited.
4. Rearward mounting screw.
5. Blower motor resistor/relay.

Important

^ Care must be taken when removing the blower motor resistor/relay. The resistor/relay is a ceramic card.

Install or Connect

1. Blower motor resistor/relay card and attaching screws.
2. Rearward mounting screw.

Tighten
^ Screw to 1.9 N.m (16 lb. in.).

3. Tighten both forward mounting screws.

Tighten
^ Screws to 1.9 N.m (16 lb. in.).

4. Electrical connectors to blower motor resistor/relay.
5. Right-side instrument panel insulator.