Fog/Driving Lamp: Adjustments

Description:

Horizontal aim is not adjustable on this vehicle. Vertical aim is done by an adjusting nut located on the rear of the foglamp.

PREPARATION
- If any service has been performed on the vehicle, make sure that all of the components are back in their original place.
- Place the vehicle on a level surface.
- Stop all other work on the vehicle.
- Fill fuel tank to half full.
- If the vehicle is intended for hauling heavy loads or tows a trailer, these loads should be simulated.

PROCEDURE
1. Move vehicle to level area and park the vehicle 7.6 m (25 feet) away from the target screen.
2. Measure from center of foglamp to ground line.
3. Turn foglamps on. The top of the foglamp beam image on the target screen should be 101.6 mm (4 inch.) below center of foglamp lens height.
4. Adjust the foglamp as required, using the adjusting nut on the rear of the foglamp.