Compressor/Condenser Hose

Compressor Condenser Hose Assembly:

Remove or Disconnect

1. Air cleaner and duct assembly.
2. Recover refrigerant. Refer to "Refrigerant Recovery and Recycling, Adding Oil, Evacuating and Recharging Procedures".
3. Compressor line block fitting at accumulator.
4. Compressor line block fitting at rear suction line (Rear A/C, C34 only).
5. Compressor line block fitting at condenser.
6. Compressor condenser hose assembly at compressor.
7. Compressor condenser hose assembly.

Important
Remove and discard all used O-rings and sealing washers.

Install or Connect

1. Compressor condenser hose assembly.
2. Compressor condenser hose assembly at rear of compressor, using new sealing washers.

Tighten
^ Nut to 33 N.m (24 lb. ft.).

3. Compressor line block fitting at condenser.

Tighten
^ Bolt to 16 N.m (11 lb. ft.).

4. Compressor line block fitting at rear suction line (Rear A/C, C34 only).

Tighten
^ Bolt to 16 N.m (11 lb. ft.).

5. Compressor line block fitting at accumulator.

Tighten
^ Bolt to 16 N.m (11 lb. ft.).

6. Air cleaner and duct assembly.
7. Evacuate, charge and leak test system. Refer to Refrigerant Recovery and Recycling, Adding Oil, Evacuating and Recharging Procedures".