Ignition Lock Cylinder

^ Tools Required:
- J 41352 Modular Column Holding Fixture
- Or Equivalent

REMOVAL
Remove or disconnect the following:
1. Negative (-) battery cable.
2. Disable the Supplemental Inflatable Restraint (SIR) system.
3. Inter steering shaft assembly (65) from shaft assembly (37).
^ Remove pinch bolt (66).

CAUTION: Once steering column is removed from vehicle, the column is extremely susceptible to damage.

4. Lower or remove steering column from vehicle.
^ Secure steering column to Modular Column Holding Fixture.






^ Place holding fixture into vise.






^ Inspect the steering shaft assembly for accident damage.
5. Tilt lever.
6. Two pan head tapping screws (13) from lower shroud (28).
7. Lower shroud (28).
^ Tilt shroud (28) down and slide back to disengage locking tabs.
8. Two torx head screws (14) from upper shroud (10).
9. Lift upper shroud (10) to gain access to lock cylinder hole.
A. Hold key in "START" position.
B. Using 1/16-inch alien wrench push on lock cylinder retaining pin.
C. Release key to "RUN" position and pull steering column lock cylinder set (17) from lock module assembly (15).
D. Remove upper shroud (10).
10. Shift lever.
11. Shift lever seal (16).
12. Shroud protector (27) from lower shroud (28).

INSTALLATION
Install or connect the following:
1. Shift lever seal (16).
2. Shift lever.
3. Shroud protector (27) to lower shroud (28).
4. Move shift lever seal (16) and multifunction lever seal to ease in installation of upper and lower shrouds.
5. Upper shroud (10) and steering column lock cylinder set (17).
A. Key installed in lock cylinder (17) and in "RUN" position.






B. Ensure sector in lock module assembly (15) is in "RUN" position.
C. Lock cylinder (17) to upper shroud (10).
D. Line up locking tab and positioning tab with slots in lock module assembly (15) and push cylinder (17) into position.
6. Two torx head screws (14) to upper shroud (10).
^ Tighten screws (14) to 1.4 Nm (12 lb in).
7. Lower shroud (28),
^ Ensure that slots on lower shroud (28) engage with tabs on upper shroud (10).
^ Tilt lower shroud up and snap shrouds together.
8. Two pan head tapping screws (13) to lower shroud (28).
^ Tighten screws (13) to 6.0 Nm (53 lb in).
9. Shift lever seal (16) and multifunction lever seal into position.
10. Tilt lever.
11. Raise or install steering column to vehicle.
12. Inter steering shaft assembly (65) to shaft assembly (37).
^ Tighten pinch bolt (66) to 47 Nm (35 lb ft).
13. If all service operations are completed, enable the SIR system.
14. Negative (-) battery cable.