Turn Signal & Multifunction Switch
REMOVALRemove or disconnect the following:
1. Make sure lever is in center of "OFF" position.
2. Battery ground (negative) cable.
3. Disable Supplemental Inflatable Restraint (SIR).
4. Inflatable restraint steering wheel module.
5. Steering wheel.
6. Bolts/screws from lower column cover.
^ Tilt cover down and slide back to disengage locking tabs.
7. Lower column cover.
8. Bolts/screws from upper column cover.
9. Upper column cover.
10. Wire harness strap.
11. Two wire harness straps from steering column wire harness.
12. Steering column bulkhead connector from vehicle wire harness.
13. Gray and black connectors of switch from column bulkhead connector.
14. Bolts/screws from turn signal and multifunction switch.
15. Turn signal and multifunction switch.
INSTALLATION
Install or connect the following:
1. Turn signal and multifunction switch.
^ Use small flat-bladed tool to compress electrical contact and move turn signal and multifunction switch into position.
^ Electrical contact must rest on canceling cam.
2. Bolts/screws to turn signal and multifunction switch.
^ Tighten bolts/screws to 6 Nm (53 lb in).
3. Gray and black connectors of switch to column bulkhead connector.
4. Steering column bulkhead connector to vehicle wire harness.
5. Two wire harness straps to steering column wire harness.
6. Wire harness strap.
7. Upper column cover.
8. Bolts/screws to upper column cover.
^ Tighten bolts/screws to 4 Nm (38 lb in).
9. Lower column cover.
10. Bolts/screws to lower column cover.
^ Tighten bolts/screws to 4 Nm (38 lb in).
11. Make sure the lever is in the center or "OFF" position.
12. Steering wheel to column.
13. Inflatable restraint steering wheel module.
14. Enable SIR.
15. Battery ground (negative) cable.