Radio Replacement (w/o Remote CD Player)

REMOVAL PROCEDURE
1. Remove the instrument panel accessory trim plate.
2. Remove the bolts/screws from the audio system.
3. Pull straight out from the instrument panel in order to remove the audio system.
4. Disconnect the electrical connectors.
5. Remove the antenna lead.

INSTALLATION PROCEDURE
1. Connect the electrical connectors.
2. Install the antenna lead.
3. Push in on the audio system in order to install the audio system.
Ensure that the alignment pin is located in the proper position.

NOTICE: Refer to Fastener Notice in Cautions and Notices.

4. Install the bolts/screws to the audio system.

Tighten
Tighten the bolts/screws to 2.5 N.m (22 lb in).

5. Install the instrument panel accessory trim plate.