Support Bracket Replacement - Overhead Console

REMOVAL PROCEDURE

TOOLS REQUIRED
J 38778 Door Trim Pad Clip and/or Garnish Trim Clip Remover.




1. Remove the video entertainment system overhead console.
2. Remove the video screen.
3. Use the J 38778 in order to remove the interface module.
4. Use the J 38778 in order to remove the support bracket push-in retainers.
5. Remove the bolt from the left corner of the support bracket.




6. Carefully slide the support bracket towards the front of the vehicle.
7. Remove the support bracket from the roof.

INSTALLATION PROCEDURE




1. Install three strips of foam tape across the back side of the support bracket.
2. Insert the pointed end of the support bracket through the hole in the headliner towards the rear of the vehicle.
3. Secure the rear of the support bracket into place by snapping the retainer at the pointed end of the support bracket to the roof bow.
4. Secure the front of the support bracket into place by installing new push-in retainers.

NOTICE: Refer to Fastener Notice in Cautions and Notices.

5. Install the bolt to the left corner of the support bracket.

Tighten
Tighten the support bracket bolt to 2 N.m (18 lb in).

6. Secure the interface module to the support bracket using the hook and loop retainer.
7. Install the video screen.
8. Install the video entertainment system overhead console.