Air Inflator Switch Replacement (LWB Without HVAC)

REMOVAL PROCEDURE

CAUTION: Before removing or installing any electrical unit or when a tool or equipment could easily come in contact with "live" exposed electrical terminals, disconnect the negative battery cable to help prevent personal injury and/or damage to the vehicle or components. Unless instructed otherwise, the ignition switch must be in the "OFF" or "LOCK" position.

1. Disconnect the negative battery ground cable.
2. Remove the inflator air valve opening cover by pulling the lever inboard.
3. Remove the inflator control access panel retainers.
4. Disconnect the electrical connector from the inflator switch (1).
5. Remove the switch from the inflator control panel by depressing the retainers on the inflator switch (1).





INSTALLATION PROCEDURE
1. Install the inflator switch (1) to the inflator control panel (snaps into place).
2. Reconnect the electrical connectors to the inflator switch.
3. Install the inflator control access panel retainers.

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

4. Install the inflator air valve opening cover by pushing the lever outboard.

Tighten the bolts to 3 Nm (27 inch lbs.).

5. Reconnect the negative battery ground cable.