Instrument Panel Accessory Trim Plate Replacement

REMOVAL PROCEDURE
1. Open the ashtray.
2. Remove the screws from the IP accessory trim plate.
3. Use a small, flat-bladed tool in order to remove the upper tabs on the IP accessory trim plate from the instrument panel.
4. Disconnect the electrical connectors.
5. Remove the IP accessory trim plate from the instrument panel.

INSTALLATION PROCEDURE
1. Install the IP accessory trim plate to the instrument panel.
2. Connect the electrical connectors.
3. Align the upper tabs of the IP accessory trim plate to the instrument panel.

NOTICE: Refer to Fastener Notice in Cautions and Notices.

4. Install the screws to the IP accessory trim plate.

Tighten
Tighten the screws to 2 Nm (18 lb in).

5. Close the ashtray.