Engine Support Fixture

INSTALLATION PROCEDURE

^ TOOLS REQUIRED
- J28467-B Universal Engine Support Fixture
- J28467-500 Engine Support Fixture





1. Remove the right side engine mount strut.
2. Install the J28467-500.





3. Install the spreader bar to the right engine mount strut bracket.





4. Install the spreader bar to the engine right side engine lift hook.
5. Install the J28467-6A.





6. Install the J28467-7A to the engine left side engine lift hook.
7. Install the J28467-34.
8. Install the J28467-6A.





9. Install the J28467-8A to the spreader bar.
10. Install the J28467-34.
11. The engine support fixture upper portion installed.


IMPORTANT: Perform the following steps only if you are disconnecting both of the powertrain mounts from the frame or the powertrain.





12. Raise and support the vehicle.

CAUTION: THE UTILITY STRAPS MUST BE INSTALLED IN ORDER TO PREVENT FORWARD MOVEMENT OF THE POWERTRAIN. IF THE UTILITY STRAPS ARE NOT INSTALLED, THE POWERTRAIN WILL MOVE WHICH MAY CAUSE PERSONAL INJURY AND VEHICLE DAMAGE.





13. Install the J28467-500UPD to the engine.





14. Install the J28467-500UPD opposite end to the underbody rail.





15. Install the OTHER J28467-500UPD to the transaxle.





16. Install the J28467-500UPD opposite end to the underbody rail.
17. Tighten both of the J28467-500UPD utility straps in order to prevent forward movement of the powertrain.

REMOVAL PROCEDURE
1. Remove both of the J 28467-500UPD.
2. Lower the vehicle.
3. Remove the J28467-34.
4. Remove the J28467-7A.
5. Remove the J28467-6A.
6. Remove the J28467-34.
7. Remove the J26467-8A.
8. Remove the J28467-6A.
9. Remove the J28467-500.
10. Install the right side engine mount strut.