Brake Lamp: Service and Repair

REMOVAL PROCEDURE
The high-mounted stop lamp has a LED circuit board which is not serviced as a separate part. The entire high-mounted stop lamp must be replaced if the LED circuit board fails.
1. Remove the screws from the high-mounted stop lamp.
2. Remove the high-mounted stop lamp from the body.
3. Disconnect the electrical connector.

INSTALLATION PROCEDURE
1. Connect the electrical connector.
2. Install the high-mounted stop lamp to the body.

NOTICE: Refer to Fastener Notice in Cautions and Notices.

3. Install the screws to the high-mounted stop lamp.

Tighten
Tighten the screws to 6 N.m (53 lb in).