Door Switch: Service and Repair

REMOVAL PROCEDURE




CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the negative battery cable.

IMPORTANT:
^ Front door jamb switches are located in the front door latches. Refer to Lock Replacement - Front Door in Doors.
^ Always use a new sliding door jamb switch. Do not reuse or try to adjust a used switch.
^ When a new sliding door jamb switch is installed and the sliding door is closed for the first time, the plunger is forced into the sleeve and automatically adjusts the sliding door jamb switch for the sliding door.
2. Open the sliding door screw from the sliding door jamb switch bracket.
3. Remove the sliding door jamb switch from the pillar.
4. Disconnect the electrical connector from the sliding door jamb switch.

INSTALLATION PROCEDURE




1. Connect the electrical connector to the sliding door jamb switch.
2. Install the sliding door jamb switch to the pillar.

NOTICE: Refer to Fastener Notice in Cautions and Notices.

3. Install the screw to the sliding door jamb switch bracket.

Tighten
Tighten the screw to 6 N.m (53 lb in).

4. Connect the negative battery cable.
5. Close the sliding door in order to reset the sliding door jamb switch.