Headlamp Aiming-Using the Headlamp Aimer

NOTICE: In order to avoid any possibility of damage, regardless of weather a vehicle has glass or plastic headlamps, it is recommended that the headlamps not be illuminated when using aiming equipment which uses a suction cup device for attachment.




TOOLS REQUIRED
J25300-E Headlamp Aimer
1. Adjust the headlamp aimers (1) for the floor level.
2. Select the appropriate adapter (6) from the J 25300-E.
3. Set the adjustment rods (3) to the numbers shown on the front of the headlamp console.
4. Attach the adapter (5) to the aimer from J 25300-E.
5. Attach the aimers to the headlamp capsule.
6. Ensure that the adjustment rods (2) contact the aiming pads. You may have to add or remove an extension stud.
7. Aim the headlamps according to the aiming tool manufacturer's instructions.
8. If any adjustments are needed, perform the adjustment in the following manner:
- For horizontal adjustments, make the adjustment with the inner adjustment screw.
- For vertical adjustments, make the adjustment with the upper adjustment screw.