Second Repair

IMPORTANT: The following repair procedures should only be used in the event that the inflatable restraint Sensing and Diagnostic Module (SDM) mounting studs and for fasteners are damaged to the extent that the SDM can no longer be properly mounted.


Second Repair

1. Remove and discard the fastener.
2. Use a larger fastener GM P/N 10267482 with washer GM P/N 11500305.
3. Install the SDM mounting fasteners (1).
Tighten
Tighten fasteners to 15 N.m (134 lb. in). Refer to Fastener Notice in Vehicle Damage Warnings.