Tilt Head Assembly

^ Tools Required:
- J 23653-SIR Lock Plate Compressor
- J 21854-01 Pivot Pin Remover

REMOVE OR DISCONNECT
1. Do all steps, "Remove or Disconnect", SIR COIL ASSEMBLY.
2. Do steps 6 and 7, "Remove or Disconnect", T/S & MULTIFUNCTION SWITCH ASM.
3. Do steps 2 through 6, "Remove or Disconnect", LINEAR SHIFT ASM (REMOVAL).
4. Do steps 2 through 7, "Remove or Disconnect", UPPER TILT HEAD COMPONENTS.
5. Do steps 6 through 8, "Remove or Disconnect", LOCK MODULE ASM.
6. Do steps 4 through 6, "Remove or Disconnect", TILT SPRING.





7. Two pivot pins (56) using J 21854-01.
8. Steering column tilt head assembly (26).
^ Pull tilt arm to disengage steering wheel lock shoes from dowel pins in steering column support assembly (57).

INSTALL OR CONNECT

NOTICE: Refer to the fastener NOTICE in Service Precautions. Failure to do so may result in component damage or malfunction of steering column.

1. Steering column tilt head assembly (26).
^ Using tilt lever position lock shoes to dowel pins.
^ Rotate head assembly (26) until holes for pivot pins (56) line up.
2. Two pivot pins (56).
A. Lubricate with lithium grease.
B. Press pins until firmly seated two places.
C. Stake pins (56) three locations two places.
3. Do steps 1 and 2, "Install or Connect", TILT SPRING.
4. Do steps 2 through 4, "Install or Connect", LOCK MODULE ASM.
5. Do steps 1 through 6, "Install or Connect", UPPER TILT HEAD COMPONENTS.
6. Do steps 1 through 6, "Install or Connect", LINEAR SHIFT ASM (REMOVAL), and "Adjust and Inspect".
7. Do steps 1 through 6, "Install or Connect", T/S & MULTIFUNCTION SWITCH ASM.
8. Do all steps, "Install or Connect", SIR COIL ASSEMBLY.