Ignition Lock Cylinder - Cylinder Rotates

REMOVAL PROCEDURE





1. Disconnect the battery negative cable.
2. Disable the SIR system.
3. Remove the inflator module.
4. Remove the steering wheel.
5. Remove the tilt lever.
6. Remove ONLY the steering column LOWER shroud. Refer to Steering Column Trim Covers - Disassemble in Steering Column/Service and Repair/Off Vehicle
7. Remove the steering column upper shroud FASTENERS ONLY.
8. Lift the upper steering column shroud in order to gain access to the lock cylinder access hole (1).
9. Insert the bent tip awl into the ignition lock cylinder access hole (1).





10. Turn the ignition lock cylinder to START.





11. Use the bent tip awl in order to push down on the ignition lock cylinder retainer.
12. Turn the ignition lock cylinder to RUN.





13. Remove the ignition lock cylinder from the lock module.

INSTALLATION PROCEDURE





1. Insert the ignition lock cylinder through the upper shroud.
2. Align the lock cylinder retaining tab and the position tab with the slots in the lock housing.
3. Push the lock cylinder into the lock housing completely.
4. Install the steering column upper shroud.
5. Install the lower shroud.
6. Install the tilt wheel lever.
7. Install the steering wheel.
8. Install the inflator module.
9. Enable the SIR system.
10. Connect the battery negative cable.