Front Wheel Drive Shaft Oil Seal Replacement (Right)

REMOVAL PROCEDURE





1. Raise and support the vehicle.
2. Remove the right front tire and wheel.
3. Remove the right engine splash shield.
4. Remove the right stabilizer shaft link from the right lower control arm.
5. Remove the right tie rod end from the right steering knuckle.
6. Remove the right lower ball joint from the right steering knuckle.
7. Remove the right drive axle from the transaxle.
8. Secure the right drive axle to the right steering knuckle and strut.
9. Use a screwdriver or other suitable tool to pry out the seal. Do NOT damage the seal bore.

INSTALLATION PROCEDURE

^ Tools Required
- J 29130 Right Side Axle Seal Installer
- J 37292-B Axle Seal Protector

1. Use a light wipe of transaxle fluid to lubricate the seal lip.
2. Use the J 29130 to install a new seal.
3. Install the J 37292-B in the seal.
4. Install the drive axle to the transaxle.

IMPORTANT: Carefully guide the axle shaft past the lip seal. Do NOT allow the shaft splines to contact any portion of the seal lip surface or damage to the seal will occur.

5. Remove the J 37292-B.
6. Install the right lower ball joint to the right steering knuckle.
7. Install the right tie rod end to the right steering knuckle.
8. Install the right stabilizer shaft link to the right lower control arm.
9. Install the right engine splash shield.
10. Install the right front tire and wheel.
11. Lower the vehicle.
12. Adjust the fluid level.
^ Transmission Fluid Checking Procedure
^ Fluid and Lubricant Recommendations in Maintenance and Lubrication
^ Approximate Fluid Capacities in Maintenance and Lubrication

13. Inspect for proper completion of the repairs.
14. Inspect for proper fluid level.
15. Inspect for fluid leaks.