Door Up/Down Adjustment - Sliding

Door Up/Down Adjustment - Sliding

Removal Procedure

1. Remove the plastic plugs from the lower front of the sliding door inner trim panel in order to gain access to the sliding door lower roller bracket to door bolts.
2. Remove the close-out panel on the center rear of the sliding door inner trim panel in order to gain access to the sliding door center roller bracket bolts.





Important: Loosen only 1 bolt at a time on the following brackets:


* The sliding door lower roller bracket

* The sliding door center roller bracket


If you loosen more than 1 bolt at a time, you may cause a loss of sliding door alignment.


3. Loosen 1 of the bolts on the sliding door lower roller bracket.
4. Adjust the front edge of the sliding door up or down, as needed.



Installation Procedure






Notice: Refer to Fastener Notice in Cautions and Notices.

1. Tighten the bolt that you loosened on the sliding door lower roller bracket.

Tighten the sliding door lower roller bracket bolt to 25 N.m (18 lb ft).

2. Install the close-out panel on the center rear of the sliding door inner trim panel in order to cover the sliding door center roller bracket bolts.
3. Install the plastic plugs to the lower front of the sliding door Inner trim panel in order to cover the sliding door lower roller bracket bolts.