Wiper Arm Replacement

WIPER ARM REPLACEMENT

TOOLS REQUIRED
J 39822 Wiper Arm Puller

REMOVAL PROCEDURE




1. Turn the ignition switch to the ACCY position.
2. Set wiper switch to the PULSE position.
3. Turn off the ignition when the wiper arms are in the innerwipe position and not moving.
4. Disconnect the washer hose from the washer nozzle.
5. Remove the wiper arm nut cover.
6. Remove the wiper arm nut.
7. Using the J 39822, remove the wiper arm from the wiper drive system module.
8. Remove the wiper blade from the wiper arm.

INSTALLATION PROCEDURE




1. Install the wiper blade onto the wiper arm.
2. Position the wiper arm onto the wiper drive system module.
3. Measure the distance from the wiper blade tip to the solid edge of the windshield blackout. Position the wiper arms at the following distances:
- LH - 147 mm (5.79 in) above the glass blackout.
- RH - 123 mm (4.84 in) below the glass blackout.

IMPORTANT: Hold the measuring device at 90 degrees (perpendicular) to the wiper blade tip.




4. Install the wiper arm nut.

Tighten the nut to 48 N.m (35 lb ft).

NOTE: Refer to Fastener Notice in Service Precautions.

5. Install the wiper arm nut cover.
6. Install the washer hose to the washer nozzle.
7. Inspect the wipers for proper operation.