Instrument Panel Cluster (IPC) - Replacement

INSTRUMENT PANEL CLUSTER (IPC) REPLACEMENT

REMOVAL PROCEDURE
1. Remove the IP cluster trim plate.

IMPORTANT: The ignition switch must be in the OFF position when removing the instrument panel cluster.




2. Remove the screws from the IP cluster to instrument panel.




3. Remove the IP cluster from the instrument panel.
4. Disconnect the electrical connectors.

INSTALLATION PROCEDURE




1. Connect the electrical connectors.




2. Position the IP cluster to the instrument panel.




3. Install the screws to instrument panel cluster.

Tighten the screws to 2.5 N.m (22 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the instrument cluster trim plate.