Ignition Lock Cylinder - Rotates

Ignition Lock Cylinder Replacement (Cylinder Rotates)

Removal Procedure

1. Disconnect the battery negative cable.

Caution: Refer to SIR Caution in Service Precautions.

2. Disable the SIR system. Service and Repair
3. Remove the inflator module. Steering Wheel Module Replacement
4. Remove the steering wheel. Steering Wheel
5. Remove the tilt lever. - With Tilt Column
6. Remove only the steering column LOWER trim cover. Steering Column Trim Covers
7. Remove only the steering column upper shroud fasteners. Steering Column Trim Covers





8. Lift the upper steering column shroud in order to gain access to the lock cylinder access hole (1).
9. Insert the bent tip awl into the ignition lock cylinder access hole (1).





10. Turn the ignition lock cylinder to START.





11. Use the bent tip awl in order to push down on the ignition lock cylinder retainer.
12. Release the ignition lock cylinder to RUN.





13. Remove the ignition lock cylinder from the ignition lock cylinder case.

Installation Procedure





1. Insert the ignition lock cylinder through the upper
2. Align the lock cylinder retaining tab and the position tab with the slots in the lock housing.
3. Push the lock cylinder into the ignition lock cylinder case completely.
4. Install the LOWER trim cover.
5. Install the tilt wheel lever.
6. Install the steering wheel.
7. Install the inflator module.
8. Enable the SIR system.
9. Connect the battery negative cable.