Hazard Warning Flasher: Service and Repair

HAZARD AND TURN SIGNAL FLASHER REPLACEMENT

REMOVAL PROCEDURE
1. Remove the instrument panel (I/P) center trim bezel.




2. Remove the screws that retain the hazard and turn signal flasher switch to the I/P center stack. Remove the switch.




3. Disconnect the electrical connector from the hazard and turn signal flasher switch.

INSTALLATION PROCEDURE




1. Align the switch with the trim bezel and fasten in place.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screw to 2.5 N.m (22 lb in).




2. Connect the electrical connector to the hazard and turn signal flasher switch.
3. Install the I/P center trim bezel.
4. Test the flasher switch for proper operation.