Garnish Molding Replacement - Center Pillar Upper

Garnish Molding Replacement - Center Pillar Upper

Removal Procedure





1. Unsnap the fastener cover from the D-ring bolt .
2. Remove the D-ring bolt.
3. Remove the shoulder belt from the center pillar.




4. Using a flat-bladed tool, remove the height adjuster button from the shoulder belt, by prying at the top and the bottom slots and pulling on the button.




5. Starting at the top, gently pull on the garnish molding to disengage the attaching clips.



Installation Procedure





1. Position the center pillar garnish molding over the lower garnish molding with the bottom tabs behind the lower molding.
2. Gently push at the clip locations to install the garnish molding.
3. Insert the weatherstripping over the trim edge.
4. Install the fastener cover to the garnish molding.




5. Install the height adjuster knob.

Notice: Refer to Fastener Notice in Cautions and Notices.

6. Install the shoulder belt assembly and fasteners.

Tighten the fasteners to 50 N.m (37 lb ft).

7. Press on the shoulder belt fastener cover until the cover snaps closed.
8. Ensure proper operation of the seat belt.