Steering Column Trim Covers Replacement

Steering Column Trim Covers Replacement

Removal Procedure
1. Disable the SIR system.





2. Unsnap and remove the upper steering column cover.
3. Remove the lower steering column cover screws.





4. Unsnap and remove the ignition switch bezel.
5. Remove the lower trim cover.

Installation Procedure
1. Position the upper and lower shrouds.





2. Apply light pressure until they snap in place.





3. Install the ignition switch bezel.

4. Notice: Install the shroud fasteners.

^ Tighten the lower steering column cover screws to 1.5 Nm (13 inch lbs.).
5. Enable the Restraint system.