Upper Limit Switch Replacement - Sit-N-Lift

Upper Limit Switch Replacement - Sit-N-Lift

Removal Procedure

1. Remove the upper seat trim.
2. Remove the chain cover.




3. Remove the bolts from the limit switch bracket.
4. Disconnect the electrical connector.




5. Remove the switch.

Installation Procedure





Notice: refer to Fastener Notice.

1. Install an upper and lower stay bracket to the seat base. Secure the bracket with a bracket bolt.

Tighten the bolts to 50 N.m (35 lb ft).




2. Install the limit switch and the bracket to the seat base.




3. Install the bolts to the limit switch bracket.

Tighten the bolts to 5.8 N.m (50 lb in).

4. Connect the electrical connector.

Important: The switch body is delicate. Adjust and tighten the switch carefully.

5. Set the limit switch to stop the lift in the proper location. Make the adjustment at the top hole on the slotted mounting bracket.




6. Tighten the mounting screws until the screws are snug, yet the switch can still be moved easily by hand.
7. Operate the lift to the proper location. Slide the switch forward until the switch makes contact and clicks into place.
8. Hand tighten the switch.




9. Adjust the lift stop position. The lift should stop when the left post makes contact with the rubber bushing, and the right post is 2-4 mm (0.04-0.08 in) from contacting the metal hook.
10. Inspect the seat for proper installation.
11. Install the chain cover.
12. Install the upper seat trim.