Front Steering Knuckle: Service and Repair

Steering Knuckle Replacement

Tools Required

J 24319-B Steering Linkage and Tie Rod Puller

Removal Procedure

1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Remove the front wheel drive shaft bearing.
4. Remove the front lower control arm ball stud.
5. Remove the outer tie rod end from the steering knuckle. Use the J 24319-B.




6. Scribe the strut to the knuckle.




7. Remove the bolts connecting the strut to the knuckle.
8. Remove the knuckle from the vehicle.

Installation Procedure

1. Install the knuckle to the vehicle.





Notice: Refer to Fastener Notice.

2. Install the bolts which connect the strut to the knuckle.

Tighten the strut to knuckle bolts to 112 N.m (83 lb ft).

3. Install the outer tie rod to the steering knuckle.
4. Connect the front lower control arm ball stud to knuckle.
5. Install the front wheel drive shaft bearing.
6. Install the tire and wheel assembly.
7. Lower the vehicle.