Quarter Window Replacement (With A20 Power)

Quarter Window Replacement (With A20 Power)

Removal Procedure






Important: Before removing a stationary window, apply a layer of masking tape around the perimeter of the painted surfaces and inner trim of the window.

1. Remove the body side rear upper finish panel.
2. Remove the rear corner upper finish panel.
3. Open the body side window to the full open position.
4. Disconnect the electrical connector (4) from the power window actuator (5).
5. Disconnect the actuator arm from the rear window hinge.
6. Remove the body side window hinge nuts (2).
7. Remove the body side window (1) from the opening.
8. Inspect the quarter window weatherstrip. Replace the weatherstrip, if damaged.
9. Remove the hinge screw (3) from the window (1).

Installation Procedure






Notice: refer to Fastener Notice.

1. Install the body side window hinge screw (3) to the window (1).

Tighten the screw (3) to 1.6 N.m (1.4 lb in).

2. Install the body side window to the body side opening.
3. Install the body side window hinge nuts (2).

Tighten the nuts (2) to 10 N.m (89 lb in).

4. Secure the window hinge to the actuator arm.
5. Connect the electrical connector (4) to the power window actuator (5).
6. Inspect the body side window for proper operation.
7. Close the body side window.
8. Remove the masking tape from around the perimeter of the painted surfaces and inner trim of the window.
9. Install the rear corner upper finish panel.
10. Install the body side rear upper finish panel.